Panasonic OMNIVISION VHS PV-M2058 - Manual (Page 30)

VCR Plus+ Programming
Easy
k^Before you begin, make sure...
Q The clock is set.
□ VCR Plus+ Setup is complete
(See pages 28,29).
Model PV-M2058 unit is shown here.
PROGRAM TIMER Indicator
1
4
7
¿
Modei PV-M2058 remote
is shown here.
Use normal Timer Recording
steps if:
• the PlusCode for a program is
not listed.
• you anticipate the program, such
as a sporting event, to run over
the scheduled stop time.
See page 19 to:
• cancel a timer recording in
progress.
• replace program contents.
• review or clear program contents
once set.
‘Important: If the remote control POWER, CH AY , ACTION, PROG,
INDEX, ON-TIMER, R-TUNE, FM/TV and ADD/DLT button does
not work when pressed, press the TV/VCR button on the
remote and try the button again.
1
Press PROG* to display the SET
PROGRAM screen.
2
Press
AY
to select “VCR
Plus-i- PROGRAM” and then
press ► to display the Plus
Code screen.
............SET PROGRAM.....................
VCR Plus* PROGRAM
TIMER PROGRAM
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
O Press NUMBERED keys to enter
the PlusCode number from your
local TV listings.
To Make Corrections
Press ^ repeatedly to delete the PlusCode
number. Then, enter the correct number.
ENTER PLUSCODE NUMBER
123456
USING 0-9 KEYS
BACKSPACE:-4 KEY
ENTER :PHOG KEY
4
Press PROG to lock in your
program.
5
Press the 1, 2, or 3 key to select
the program type.
1 ONCE
2 DAILY(UON-FRI)
3 WEEKLY
TO SELECT PUSH 1, 2 OR 3
END : PROG KEY
6
Press
AT
and ► to select and
set each of the remaining items as
follows.
Remaining Items:
• Category [N/A (not applicable), SPORTS,
MOVIE, COMEDY, MUSIC. DRAMA]
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► or to move the
cursor to the right or left, and then make
the correction.
28TUE12:30P13:30P 69
\ I /
CATEGORY ;||
SELECT:A Y KEY
SET
'■* ► KEY
END :PR0G KEY
If you use connection
type "A” on page 28, the
channei shown in this
on-screen display will
always be the cable box
output channel number.
7
Press PROG to end the program.
• This screen appears for confirmation.
P DT START STOP CH SPD
1 day 9: (X)a 12:00a 08 SP
CANCEL:ADD/DLT KEY
SELECT 1-0:A
y KEY
ENTER ;► KEY
END ;PROG KEY
8
Press PROG twice to exit this mode
and return to the normal screen.
• The PROGRAM TIMER indicator iights on
the front panel.
• If you’re using a cable box, make sure that
it is tuned to the desired channel and the
power is left on for timer recording.
LEAVE CABLE BOX POWER ON
FOR TIMER RECORDING
• This display appears if
you use a cable box.
You can obtain unlisted PlusCode numbers by calling 1-900-454-7587. Call costs approximately $.95 per minute.
Avoid overlapping program times.
An on-screen display will indicate if an invalid PlusCode number has been entered.
An on-screen display will indicate when all timer programs are full.
30