4 troubleshooting procedure, 4 troubleshooting procedure -21, Troubleshooting procedure – Panasonic 8000 User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Troubleshooting - VAS__________
2 IPSec and IKE troubleshooting
Figure 2-7 Troubleshooting flowchart of SA setup in Phase 2
2.3.4 Troubleshooting procedure
Step 1 Check whether two ends of the tunnel are reachable with no IPSec policy applied.
Use the undo ipsec policy command on two ends of the IPSec tunnel.
On PC A, ping PC B.
A failed ping indicates a faulty route or link between PC A and PC B. For information about
removing the fault, see
Nor^tel Secure Router 8000 Series Troubleshooting - IP Routing
(NN46240-706).
If the ping succeeds, continue with the following steps.
Step 2 Check whether the SA is set up in Phase 1.
Issue 01.01 (30 March 2009)
Nortel Networks Inc.
2-21