Panasonic 8000 - Manual (Page 121)

Nortel Secure Router 8000 Series
Troubleshooting - VAS__________
3 Firewall troubleshooting
Command Description
display traffic policy interface
[ {
interface-type interface-number }
[ inbound | outbound | dlci
dlcinumber ]
Displays all policies applied on the synchronous
interfaces with FR (Frame Relay) as the link
layer protocol.
display this
[Nortel-Ethernet2/0/0] display this
#
interface Ethernet2/0/0
traffic-policy mypolicyl inbound
#
return
Check that the policy is applied on the interface.
display this interface
[Nortel-Ethernet2/0/0] display this interface
Ethernet2/0/0 current state : UP
Line protocol current state : UP
Description : NORTEL, Nortel Series, Ethernet2/0/0 Interface
The Maximum Transmi^t Un^t is 1500 bytes, Hold t^imer is 10(sec)
Internet Address is 4.1.1.1/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc39-1ffe
Output queue
Output queue
Output queue
(Urgent queue : Size/Length/Discards) 0/50/0
(Protocol queue : Size/Length/Discards) 0/1000/0
(FIFO queuing : Size/Length/Discards) 0/75/0
negotiation auto speed 100M , duplex full, loopback not set
display traffic policy user-defined
[Nortel] display traffic policy user-defined mypolicyl
User Defined Traffic Policy Information:
Policy: mypo^icy!
Classifier: class1
Behavior: behavior!
Firewall
Table 3-1 Description of the output information of the display traffic policy command
Main field Description
User Defined Traffic Policy Information Information about the policy defined by the
user
Policy The name of the policy
Classifier The class of the policy
Issue 01.01 (30 March 2009) Nortel Networks Inc. 3-7