Panasonic WV-CM143 - Manual (Page 7)

OPERATING PROCEDURES 4. Set the desired sequential switching interval time with
the Set Up menu.
i 5 I i 1 1
JaLU
------ /
Selection of Camera
1, Set the Power Switch on the front panel to the ON posi­
tion by pressing once.
2. Press the desired Camera Selection Switch.
Notes :
1. The normal picture will not be displayed for a few
seconds after turning on the power of the monitor.
2 . This monitor is in the sequence mode automatical­
ly by turning on the power of this unit.
3. The desired camera can be observed on the mon­
itor by pressing the desired Camera Selection
Switch even if this monitor is in the sequence
mode.
4. Also desired camera picture can be observed on
the monitor by pressing the desired Camera
Selection Switch even if this monitor is in the
Standby mode.
Caution :
When the power switch of monitor is turned ON and
OFF repeatedly in the short period of time, the camera
may not be turned ON due to the operation of miscon-
nection protection circuit.
In this case, leave the switch in the OFF position for a
few seconds before turning On again.
Sequence Mode (more than two cameras)
e
Д □ О OtóOteOfO.Ojh
fit Ruu'-^parti-'uaHiiiHPCiui ык
P я| 1 1 Ì 1 J 1 ^ 1
1. Set the Power Switch to the ON position by pressing
once.
2 . Set the Mode Selection Switch to the ON position.
3. Press the Sequence / Set up Selection Switch more
than 2 seconds.
Note: The sequential switching features the automatic
bypass circuit by detecting the presence of the
DC power for the camera so that the input connec­
tor with no camera connection is automatically
skipped.
Standby mode Monitoring picture
rjrai
---------------------- 1
□ □ о 0teC3^O.O_
"2ft '«и ÉVI
e до о ОрОшОвО.ОЛ
Ш - / 1 . iH-----------------------------------------------------------
1. Set the Power Switch to the On position by pressing
once.
2. Set the Mode Selection Switch to the ON position.
3. Press the Sequential / Set Up Switch.
4. Set the Sequential switching interval with the Set Up
menu,
5. Set the Mode Selection Switch to the STDBY position.
The picture on the monitor disappears, however the
sequential switching is actually carried and the picture
can be observed at Video Output Connector on rear of
monitor by connecting additional monitor.
6. When the picture of the desired camera is observed /
monitored, press the desired Camera Selection Switch.
7. By pressing the Sequence / Set up Selection Switch
again, the picture on the monitor disappears and back
to the sequential switching at Standby mode.
-5-