Panasonic WV-CM143 - Manual (Page 4)

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
FRONT VIEW
1. Power Switch (POWER)
This is a push-push type switch which turns the power
of the monitor on and off.
Press once and the switch remains down for turn­
ing on the power of monitor.
Press again, the switch comes up (X) for turning off
the power of the monitor.
2. Power Indicator
3. Mode Selection Switch (STAND BY (^)/ ON (X))
ON: The picture of the camera will appear on the moni­
tor.
STAND BY: The picture of the camera will not appear
on the monitor in the sequence mode, however the
picture can be observed at Video Output
Connector.
4. Input Selection Switch (EXT(^) CAMERA(X))
This selects the picture displayed on the monitor as ;
EXT: VTR playback picture which connected to Video
Input Connector can be observed.
CAMERA: Camera picture which is connected to
Camera Input Connectors can be observed.
5. Vertical Hold Control (V-HOLD)
This control is used to adjust the picture in vertically.
6. Tint Control (TINT)
Turn this control clockwise for purplish color of the pic­
ture and turn this counterclockwise for greenish color
of the picture.
7. Tint Subcontrol
8. Color Control (COLOR)
Turn this control clockwise to increase the picture color
and turn this control counterclockwise to decrease the
picture color.
9. Color Subcontrol
-2-