Panasonic WV-CM143 - Manual (Page 3)

PREFACE
The Panasonic's WV-CI\/1143 Color Monitor is designed for
use with the specified Color CCTV Camera.
Up to four cameras can be connected with this monitor
sequential or manual switching for these cameras is avail­
able.
And also by the combination with the intercom or sensor
unit, CCTV system enables.
FEATURES
As many as 4 Solid State Color Cameras can be con­
nected to Color Monitor WV-CM143 with an alarm fea­
ture. This Color Cameras can be added by using the
Camera Extension Unit WV-AD110A.
One video output displays each camera in sequence
and any camera switched to the spot monitor position
for the use of an additional monitor or video tape
recorder.
Monitor has 14' diagonal screen (13" diagonal actual
visual size)
Sequential switching interval selectable from 1, 2, 3, 4,
5, 6, 7, 8, 9, 10, 15, 20, 25 or 30 sec.
Built-in protection circuit for any misconnection.
STANDBY mode for no picture on the monitor during
the sequential switching.
Alarm control output for a buzzer or chime.
Alarm period selectable from 1, 5, 10,20, 30, 40, 50 or
60 sec.
The CCTV camera with microphone can be connected
with this monitor,
VTR playback picture can be observed.
Reset input for sequential switching from Time Lapse
VTR.
Automatic bypass circuit for skipping no camera con­
nection.
Built-in Automatic Reset Selection function for Spot
Monitor Control Input. The automatic reset time is pre­
set to approx. 60 seconds.
The following functions are available by using the Set
Up menu.
• Camera Identification Display
• Audio Selection
• Timing Selection
• Sequential Time Adjustment
• Alarm Buzzer Setting
• Alarm Time Adjustment
• Automatic Reset
• Bright Compensation Setting
The specified Color CCTV System Camera (Multiplex­
ed VD (VD2) with gen-lock) can be used with this mon­
itor due to the Camera Power Selection Switch. (CAM­
ERA INPUT 1 Connector)
PRECAUTIONS
Do not block the ventilation slots.
Do place the color monitor at least 5 cm apart from the
wall.
Do not expose the monitor to water or moisture.
Do not operate the monitor if it becomes wet. Do take
immediate action if ever the monitor does become wet.
Turn power off and refer servicing to qualified service
personnel. Moisture can damage the monitor and also
create the danger of electric shock.
Do not attempt to disassemble the monitor. To prevent
electric shock, do not remove screws or cover. There
are no user-serviceable parts inside. Refer servicing to
qualified service personnel.
Do not drop the metallic parts through slots.
This action could permanently damage the monitor.
Do turn power off immediately and refer servicing to
qualified service personnel.
-1-