Dillon EDXtreme (Old) - Manual (Page 43)

EDxtreme User Instructions 43
Radio communications not
working at all Dead batteries. Distance
is excessive, dead radio
pocket Bring remote closer to dynamometer. Allow several seconds to retrain.
Radio systems not
initialized. No “Y”
appears. Enable the radio system in the COM2 configuration of both instruments
(under Comm menu).
Displayed Change batteries in the device when the is blinking.
Operating channels mis-
matched Remote and link must be on the same operating channel. See EDxtreme
and Communicator configurations of COM2 for radio (under Comm menu)
and Common Configurations.
Excessive radio noise or
interference in
environment Remove dynamometer and Communicator from the environment. Attempt
communications in an area free of local radio signals. See Radio
Information section of the manual.
Remote reading changes to
dashes Low batteries, lost
communications See steps above for improving communications.
Display locks up on
DILLON marquee Poor connection
between EDX and
Communicator Remove batteries from EDX and Communicator, replace them and power
up.
Problem Possible Cause Solution