BendixKing KHF 990 - Manual (Page 190)

on the second line.
6. Push the VAR knob (PUSH CHAR), to place the cursor into
character mode. The CLR key, VAR knob and the CRSR knob
can now be used to enter a new address.
7. Press the ENT key. The channel group index is displayed.
8. Select the channel group that has the list of channels that this
self address is valid on with the VAR knob. Normally the channel
group is set to “ALL” for self addresses.
9. Press the ENT key. The Slot time is displayed.
10. If this self address is used in a Star Network then set the slot time
for the beginning of the self address slot.
11. Repeat steps 4 through 10 for additional self addresses
Programming a Single Address
1. Place the cursor over the address type field; this is the first
cursorable field on the top line of the display.
2. Select “Single”
3. Press the ENT key. The cursor moves over the address index.
4. Select the index of the address to modify.
5. Press the ENT key. The cursor moves over the address field on
the second line.
6. Push the VAR knob (PUSH CHAR), to put the cursor into
character mode. The CLR key, VAR knob and the CRSR knob
can now be used to enter a new address.
7. Press the ENT key. The channel group index is displayed.
8. Select the channel group that has the list of channels that this
address is valid on. This is the list of channels used when
placing a call to this address.
9. Press the ENT key. The associated self is displayed.
10. Select the self address to use when calling this address. This is
the address that this radio uses to identify itself to another radio.
11. Press the ENT key. The response time is displayed.
12. The response time is programmed in intervals of Triple Word
Services
12-10 KHF 950/990 Pilots Guide
Rev. 0
Dec/96