BendixKing KHF 990 - Manual (Page 184)

The table below shows the three data types and the sub-pages
beneath each.
Note: To exit a sub-page press the CLR key.
Data Type
Message There are 10 receive and 10 transmit messages of
90 characters each.
Edit_TX Edit transmit messages
Rev_RX Review messages received. Last one
received is in slot one.
Del_RX Delete received messages
Copy_RX Copy a received message to a transmit
message slot.
Operation System and ALE operational parameters.
Intervals Time intervals and scan rate.
Enables Enable/Disable system and ALE
parameters.
Bright Used at installation to configure unit for type
of lighting bus.
Channel ALE channel data
ALE-channel Program frequency and modulation type on
this page.
ChGrp Channel groups; there are 23 groups.
Scan List Select the channel group to be used as the
scan list.
Tune All After programming all ALE channels this
page can be used to automatically tune all
of the ALE channels.
Clear Tunes Use this page to mark all programmed
manual and ALE channels as untuned This
is useful when the control head or coupler
changes, since the tunes are stored in the
control head and are valid only for the
coupler on which the tunes were performed.
Services
12-4 KHF 950/990 Pilots Guide
Rev. 0
Dec/96