beautypg.com

BendixKing KHF 990 User Manual

Page 185

background image

AMD TRANSMIT MESSAGES

AMD transmit messages can be programmed in two ways. During
normal operation an AMD message can be programmed on the
SEND page. AMD messages can also be created or edited on the
Messages Edit_TX page per the instructions below.

1. From the system program page, select “Messages” on the bottom
line.

2. Press the ENT key. One of the message sub-pages is now dis-
played

3. Select the Edit_TX sub-page.

4. Move the cursor to the message index and select the index of the
message to program.

5. Move the cursor to the bottom line, which is the transmit message.

6. Push the VAR knob (PUSH CHAR) to put the cursor into character
mode. Use the CLR key to clear old message. Use the CRSR knob
to move the character cursor and the VAR knob to change a letter in
the cursored field.

7. Press the ENT key when finished.

8. Repeat steps 4 through 7 for each message.

OPERATION PARAMETERS

The following table describes the operation parameters that can be
programmed on the operation sub-pages.

Operation

Intervals

Time Intervals and scan rate

ActvLim

Amount of inactive time while linked

on an

ALE channel, before the

radio hangs up and

returns to

scan. The inactive time is defined
as the time since the microphone key was

last pressed.

ScnRate

A two or five Hz scan rate is selectable.

Sound

Interval between automatic sounds if
sounds are enabled.

Services

12-5

KHF 950/990 Pilots Guide

Rev. 0
Dec/96