BendixKing KHF 990 - Manual (Page 187)

next interval.
7. Repeat steps 5 and 6 until all intervals are set properly.
8. Move the cursor to the first field “Interval”
9. Select “Enables” with VAR knob.
10. Move the cursor to the last field on the second line. This is the
enable field; it shows either “ON” or “OFF”. Set to “ON” to enable
or “OFF” to disable.
11. Change the enable if it is not correct.
12. Press the ENT key. This stores any change and displays the
next enable.
13. Repeat steps 11 and 12 until all enables are set properly.
14. Press the CLR key to return to the system program page.
ALE CHANNEL DATABASE
The ALE channels, channel groups, and the scan list are pro-
grammed on these sub-pages.
1. From the system program page select “Channel” on the bottom
line.
2. Press the ENT key. One of the ALE channel sub-pages is now
displayed
3. Select the ALE-channel sub-page.
Programming ALE Channels (ALE-Channel
Sub-Page)
Select the “ALE channel” page. This is a sub-page to the system,
program, channel page. The “ALE channel” page is similar to the
manual page (MAN). Set the frequency and modulation type for
each channel on this page. See the manual channel programming
instructions
in MANUAL CHANNEL PROGRAMMING paragr aph.
When finished with programming the ALE channels, move the cursor
over the “ALE channel” field and select the “ChGrp” (channel group)
sub-page with VAR knob.
Programming Channel Groups (CHGRP Sub-Page)
Select the “ChGrp” page. This is a sub-page to the system, program,
Services
12-7 KHF 950/990 Pilots Guide
Rev. 0
Dec/96