Warpia SWP100A Installation Manual & Troubleshooting Guide - Manual (Page 36)

Wireless USB A/V Adapter Set User Guide
Page 36
Appendix B: Pairing Procedure
The PC Adapter and Device Adapter in this set are already paired and do not require
performing a pairing procedure. If you should need to perform pairing manually for any
reason (e.g. connecting to a new host PC Adapter, or adding a Device Adapter that was not
purchased in a set), please follow these steps:
To perform Pairing:
1. Ensure that a Wireless USB Host or PC Adapter is connected to the PC.
2. Remove the Device Adapter from the A/V Base and connect it directly to the host PC
USB port, do not use the A/V Base or any other accessory to connect to the PC.
3. Upon first time connection of a Device Adapter to the PC, the Pairing driver is installed
automatically.
4. Once the Pairing driver is installed, pairing is automatically performed between the host
PC and the Device Adapter, and a confirmation message is displayed.
5. Click OK to confirm and close the Cable Pairing screen.
6. Remove the Device Adapter from the PC and reconnect it to the A/V Base.