Warpia SWP100A Installation Manual & Troubleshooting Guide - Manual (Page 25)

Wireless USB A/V Adapter Set User Guide
Page 25
5.3.2.3 Adjusting Screen Resolution
Use the Resolution slider to adjust the desired resolution of the display (see circle #2 in
Figure 14).
5.3.2.4 Adjusting Color Level
Use the Colors drop-down box to select a color complexity level (see circle #2 in Figure 14).
5.3.2.5 Setting the A/V Adapter as the Primary Display
To make the A/V Adapter display the primary display:
1. Select the screen that is connected to the A/V Adapter - for example " Default Monitor on
DisplayLink Graphics Adapter " as shown in the screen above.
2. Check the option Extend the desktop onto this monitor.
(In Windows XP - Extend my Windows desktop onto this monitor ).
3. Check the option This is my main monitor.
(in Windows XP - Use this device as the primary monitor ).
4. Click OK to save the new settings.
Note : On some PCs it is necessary to disable the main display (uncheck the box marked
‘Extend the desktop onto this monitor’ for the main display) as part of the same
settings change.
The A/V Adapter remains the primary one if the PC enters Hibernate or Suspend
mode or is rebooted. If the A/V Adapter is detached, the main display becomes the
primary display again.