Talkaphone VOIP-8 VoIP Interface (8 channels) - Manual (Page 6)

VOICE OVER IP INTERFACE
Installation and Operation Manual
6
VOIP-1 LED Description
VOIP-1 Front Panel LED Definitions
LED NAME DESCRIPTION
General Operation LEDs
Power Indicates presence of power.
Boot After power up, the Boot LED will be on briefly while the
VOIP-1 is booting. It lights whenever the VOIP-1 is booting or
downloading a setup configuration data set.
Ethernet FDX. LED indicates whether Ethernet connection is half-
duplex or full-duplex (FDX) and, in half-duplex mode,
indicates occurrence of data collisions. LED is on constantly
for full-duplex mode; LED is off constantly for half-duplex
mode. When operating in half-duplex mode, the LED will flash
during data collisions. LNK. Link/Activity LED. This LED is lit if
Ethernet connection has been made. It is off when the link is
down (i.e., when no Ethernet connection exists). While link is
up, this LED will flash off to indicate data activity.
Channel-Operation LEDs
TX Transmit. This indicator blinks when voice packets are being
transmitted to the local area network.
RX Receive. This indicator blinks when voice packets are being
received from the local area network.
XS Transmit Signal. This indicator lights when the FXS-
configured channel is off-hook or the FXO-configured channel
is receiving a ring from the Telco or PBX.
RS Receive Signal. This indicator lights when the FXS-
configured channel is ringing or the FXO-configured channel
has taken the line off-hook.