Rane TTM 57SL Manual for Serato Scratch Live 2.44 - Manual (Page 40)

RANE TTM 57SL MIXER FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 2.4.4 40
(Group B4) Cueing & Looping
To access this group, press the GROUP button on the mixer, then press B4. This group gives you access to all the cue points and
looping functions. To select which of the Virtual Decks a given effect is applied to, press the mixer’s DECK button. The LED next to the
button indicates which of the Virtual Decks the software function applies.
> = Next Loop.
< = Previous Loop.
Loop On / Off (toggle). Control looping from
the footswitch.
Jump to Cue
points.
Hold the
joystick up or
down and
press a B
button to set a
cue point.
Turn to adjust, push to set the ‘loop in’ point. Turn to adjust, push to set the ‘loop out’ point.
(Group B5) Recording
To access this group, press the GROUP button on the mixer, then press B5. In this group you can select your input source, start and
stop recording, and load this new recording to either Virtual Deck.
Stop and erase the
last recording.
Start recording from
the footswitch.
Start
recording.
Scroll through your crates and library. Push to load track on left Deck. Push to load track on right Deck.
Load to
left Deck.
Load to
right Deck.
Load to
left Deck.
Load to
right Deck.
Select record
source by
scrolling up or
down.
(Group B6) Effects
The TTM 57SL has two built in effects processors. Unlike other groups, when you are in the effects group, the DECK button on the
mixer switches between these two effects processors. DECK 1 activates Processor 1, and DECK 2 activates Processor 2. Each effect
has parameters controlled by P1 and P2. See “Effects” on page 41.
The left joystick, J1, sets the BPM (tempo) multiplier. Set the BPM by tapping P1 to the beat, or manually adjust by turning P1. The
optional footswitch can also tap in the BPM. Use the left joystick to quickly halve, split, double or quadruple the tempo. The buttons
B1 through B4 set the effect’s insert point: either PGM, the Aux bus (which includes the Mic) or the Main output.
Tap to
set BPM.
Assign Effect to: PGM 1, PGM 2, AUX, MAIN
Functions vary depending on the Effect. Cue Effect. Effect on / off. Functions vary depending on the Effect.
Effect
on / off.
Select
Effect.
BPM multiplier
Wet / Dry control.
– = more dry.
+ = more wet.
up = full wet.
down = full dry.