WEATHER GUARD Model 1908 PROTECT-A-RAIL® Heavy Duty Cab Protector, Steel User Manual

Page 2

After the unit is completely wired and all fasteners are tight, you will need to apply the sealant (3 to 4 oz. tube) to all

fasteners, wiring holes, and joints that would allow water into the tubing. The key areas have been circled below. You

will also need to seal any additional holes you drill into the tubing. Warranty will be void if sealant is not applied to all

seams, openings and fasteners. The three accessory fasteners on top of the unit are sealed, but if removed, they will

need to be resealed.

If you have any questions, please give us a call. Call Toll Free 1-800-456-7865

WEATHER GUARD® products are protected by one or more of the following trademarks:

U.S. - 842268, 1661625, 1663369, 2228051, 2362167, 1750034, 2291111; Canada - 282725;

U.K. - 1400720; N.Z. - 296049; Aus. - 761964;

KNAACK LLC

420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014

815-459-6020

- NOTICE -

Any modification or unintended use of this product shall immediately void all manufacturers warranties.

Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or

unintended use of this product.

One of the following Mounting Base Kits

will be required with this rack

1916 - Mounting Base Kit for GM

1912 - Mounting Base Kit for Dodge

1913 - Mounting Base Kit for 1997 or

newer Ford light duty trucks

1915 - Mounting Base Kit for Ford super duty

and 1996 or older light duty trucks

Part No. 24-0148 REV. B ECN 5315 05/13