Satellite High Tech 2 Flush - Manual (Page 6)

- 6 -
P/N 19403 REV, B 8/08
6. Wastebasket installation:
[* Note: Hardware for wastebasket installation is in small plastic bag taped on the inside of the wastebasket.]
Carefully mark out the three hole locations using dimensions in the illustration below. (See Q)
* “Be careful not to drill through outer wall of panel"
#1) - Mark and drill the 2 lower holes in left panel using the # 10 drill bit and cordless drill. (See R)
Make sure Bracket HT2 WB - #18969 is facing up (as shown) then rivet it to the left inside panel of the wall
using Avdel silver rivets - #17436. (See S) Set wastebasket against wall and with both brackets engaged.
#2) - Mark and drill the 1 upper hole in the left panel using a 7/16” drill bit and cordless drill.
Q
6.00
Handwash
Tank
Floor
Left
Inside
Wall
7/16" bit,
Mark Hole
Through
WasteBskt
Resting
on both
Interlocked
Brackets,
Then Drill.
#10 Bit
Jack Nut
Hole
Measure First Hole.
Transfer Drill Second
Hole Using Bracket.
Mount Bracket.
8.50
#1
#2