Satellite Global (T Extrusion) - Manual (Page 8)

PN 40112 REV C 6-28-11 8
Step 10: Install Door Handle.
1. Assemble Door Handle to Door using (1) Screw, (1) Washer Fender, on the outside of front and (1)
Handle, (1) Washer Flat and (1) Nut on inside of front.
2. Tighten nut until threads are engaged with nylon in lock nut, at least one full thread must be showing,
otherwise nylon nut will loosen and fall off.
Step 11: Assemble Roof to unit.
1. Place roof on top of unit. Fasten roof to unit using (18) Rivets and (18) Washers around the roof.
Washers are installed on inside of unit.