Vermont Casting DVRT41 - Manual (Page 23)

23
DVRT41Direct Vent Gas Fireplace
10006740
Glass Information
Only glass approved by CFM Specialty
Home Products should be used on this
fireplace.
• The use of any non-approved replacement glass will
void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate appliance with glass front
removed, cracked or broken.
• Replacement glass (complete with gasket) is
available through your CFM Specialty Home
Products dealer and should only be installed by
a licensed qualified service person.
Louvre Removal
To remove louvre
assembly top, pull
louvre up and then lift
out. The louvre
assembly bottom is
hinged at the bottom
edge and swings
down. (Fig. 45)
Operating Instructions
1.
2.
Louvre
Glass Panel
FP444
Fig. 45 Remove louvre assembly
top.
Glass Cleaning
It is necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the
inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight film on the glass.
It is therefore recommended the glass be cleaned two
or three times with a non-ammonia household cleaner
and warm water (gas fireplace glass cleaner is
recommended). After the initial cleaning process the
glass should be cleaned two or three times during each
operating season depending on the environment in the
house.
Clean the glass after the first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Clamps
Window Frame
Assembly
Fireplace
Front
Glass
Panel
Glass
Panel
Pull
Clamp Hook
Fig. 46 Window frame assembly removal.
FP771
Push
Clamp Handle
Window Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating, allow time for the
components to cool.
3. Remove louvre assembly top.
4. Open the louvre assembly bottom.
5. Release the two clamps along lower edge of the
frame by pulling down on clamp handles. (Fig. 46)
6. Tilt window frame assembly out slightly at the
bottom, lift the frame up and away from the fireplace.
7. To replace window frame assembly reverse proce-
dure.
Replacement Of
Ceramic Hearth Panels
1. Remove glass.
2. Remove two (2) screws securing grate to hearth
pan. (Fig. 47)
3. Set left and right panels on hearth and bring towards
front of unit.
4. Replace grate assembly.