Welch Allyn LS200 Procedure Light - User Manual - Manual (Page 19)

Directions for Use Chapter 2 Mounting and Operating Instructions 13
4. Drive screws into the wall, allowing screw heads to protrude
11/32"(2.3mm).
5. Mount transformer by fitting round holes in the back of
transformer over mounting screws on wall, then slide
downward until secure.
6. Attach power cord to transformer.
Operating Instructions
Transport For Mobile Stand Unit
1. To prevent the light from tipping, position arm at a 45° angle
or greater, when rolling the LS200 to a new place.
2. Center arm in range of motion.
3. Unlock casters by lifting up on the tabs and hold unit at top of
pole while moving it.