Welch Allyn LS200 Procedure Light - User Manual - Manual (Page 11)

2
5
Mounting and Operating
Instructions
Mounting Instructions
Mobile Stand Setup
1. Remove stand base, pole and hardware kit from boxes.
2. Place stand base on floor with casters down and lock casters.
3. Insert pole end (A) into hole in base of mobile stand.
4. Rotate pole until it aligns with pin and drops into place.
5. Insert cap-head bolt (F) with lock washer (f) through stand
cross member into pole and tighten with 1/4" Allen wrench.
6. Carefully remove LS200 arm/luminaire assembly from box.
Hook transformer onto the factory installed mounting screws
(C) on the pole and slide down until secure.
7. Place arm/luminaire assembly on pole by sliding universal
connector (B) onto top end of the pole and align screw holes.
8. Insert 0.5" (13mm) flathead screw (b) into hole on side of
universal connector and tighten with 5/32" Allen wrench.
9. Push power cord attached to transformer into power cord
clips (D) on pole, ensuring enough slack for full range of arm
motion.
10. Attach power cord (e) to transformer.
11. To lock casters, push down on the tab on the locking casters.