Welch Allyn LS200 Procedure Light - User Manual - Manual (Page 17)

Directions for Use Chapter 2 Mounting and Operating Instructions 11
14. Place arm/luminaire assembly on extension arm by sliding
universal connector (B) onto extension arm (G) and aligning
screw holes.
15. Insert 0.5" (13mm) flathead screw (b) into hole on side of
universal connector and tighten. Move arm up and down to
check that mounting is secure.
16. Push cord into clips in underside of extension arm.
Mounting The Transformer
1. Select proper mounting hardware from hardware kit in the
LS200 mounting option box: Choose 1" (2.5cm) wood screws
for mounting into wood stud and 1" (2.5cm) sheet metal
screws and plastic anchors for concrete or brick.
2. Select a location for the transformer that is within 8' (2.4m) of
an electrical outlet and within 1.5' (0.5m) of the wall mount
plate to allow enough slack for full range of arm motion.