CITIZEN PPU-231 - Manual (Page 72)

PPU-231 User’s Manual
59 CITIZEN
ESC c 3 n (Parallel Interface Only)
[Function] Selecting the paper near end sensor valid for a paper end signal output
[Code] <1B>H<63>H<33>H
[Range] 0
≤ n ≤255
[Outline] This command selects at which paper near end sensor a paper end signal should be output.
Each bit for n has the following meaning:
Value
Bit Position
0 1
0 Paper near end Disabled Enabled
1 ∼ 7 Undefined
This printer can only select one kind of paper end detection, a paper-near-end sensor. n is
valid for the least significant bit (n0).
[Caution] This command is valid only for the parallel interface.
[Default] A default of n is what has been set with the DIP switch (DS2-1).
[Sample Program]
LPRINT CHR$(&H1B);"c3";CHR$(0);
.
………When outputting the paper-end signal at the paper end
LPRINT CHR$(&H1B);"c3";CHR$(1);
…………When outputting the paper-end signal at the paper near end
ESC c 4 n
[Function] Selecting the paper near end sensor valid for print stop
[Code] <1B>H<63>H<34>H
[Range] 0
≤ n ≤ 255
[Outline] This command selects at which paper near end sensor printing should be stopped. Each bit
for n has the following meaning:
Value
Bit Position
0 1
0 Paper near end Disabled Enabled
1 ∼ 7 Undefined
This printer can only select one kind of paper-end detection, a paper-near-end sensor. n is
valid for the least significant bit (n0).
[Default] A default of n is what has been set with the DIP switch (DS2-1).
[Sample Program]
LPRINT CHR$(&H1B);"c4";CHR$(0);
………When stopping printing at the paper end
LPRINT CHR$(&H1B);"c4";CHR$(1);
………When stopping printing at the paper near end