Warning – Torbal ATS120 User Manual
Page 4
- 3 -
Instruction Manual – ATS / BTS Moisture Analyzers
WARNING:
•
If a mistake creates a dangerous situation, immediately press the STOP key to terminate the
drying.
•
Use extreme caution when touching parts of the analyzer they may be very HOT. Wear
protective gloves when removing hot samples, even when using the pan handle (it can get very
hot).
•
Use the cover handle to open and close the Drying Chamber.
•
Always use forceps or needle-nose pliers to remove the hot disposable sample pan from the larger
permanent pan.
•
When loading a new sample into the Drying Chamber use the pan handle. Make sure the
disposable sample pan and sample are centered and that the sample has been leveled.
•
Be sure the Analyzer is in an area with good air circulation (to diffuse the heat generated by the
Drying Chamber or vapors generated from your sample), relatively low (less than 85%) or
controlled humidity (for accurate measurements), and an ambient temperature between 18ºC and
30ºC.
•
If you suspect that the analyzer has malfunctioned or it is not operating properly, immediately
STOP use and contact technical support.
Legal regulations forbid disposal of electronic
equipment in waste containers.
•
Please return this device to the point of purchase or another company that
specializes in recycling of waste electronic components.