Chapter 10: performing moisture analysis – Torbal ATS120 User Manual
Page 17
- 16 -
Instruction Manual – ATS / BTS Moisture Analyzers
After configuring all of the necessary parameters and preparing the sample, you may begin your moisture analysis by
following the steps below:
1.
Open the Drying Chamber.
2.
Using the Pan Handle, place the Disposable Pan on the Pan Support.
Note: Be sure the Pan Handle is not touching the Pan Shield.
3.
Press the T key to Tare the Disposable Pan.
4.
Place the sample on the Disposable Pan. After the Tare has been performed, the Disposable Pan can be removed from
the Pan Support by using the Pan Handle to evenly distribute the sample.
Note: Make sure the sample is evenly distributed on the Disposable Pan.
Chapter 10: Performing Moisture Analysis