Rice Lake Summit 3000 Low-Profile Package User Manual
Summit 3000, Installation manual
This manual is related to the following products:
Table of contents
Document Outline
- Summit 3000
- Installation Manual
- 1.0 Introduction and System Overview
- 2.0 Installation
- 2.1 Overview
- 2.2 Site Preparation
- 2.3 Unpacking
- 2.4 Assembly
- 2.5 Electrical Interface to Indicator
- 1. Remove the four screws using an allen wrench.
- 2. Slide the junction box assembly out of the deck.
- 3. Open and remove the top of junction box.
- 4. Push the cable end into the junction box through a cord grip.
- 5. Connect the wires to the indicator terminal (Figure 2-3) as shown in Table 2-1.
- 6. Pull out excess and tighten the cord grip to hold the cable snugly.
- Table 2-1. Junction Box Connections
- Figure 2-3. Junction Box Wiring Diagram
- 7. The cable must be routed to the indicator in a manner that will protect the cable from damage. This method of cable protection in non-washdown applications are shown in Figure 2-4. When planning cable routing, leave a loose coil of excess cable un...
- 8. When the interface cable is protected and in its final position, complete connections to the indicator. See the indicator installation manual for wiring information.
- 9. If necessary, trim corners as described in Section 3.2.
- 10. Check all strain relief fittings for tightness.
- 11. Put the cover back onto the junction box assembly and place the junction box back into the floor scale cutout.
- 12. Secure the Summit 3000 floor plate.
- 2.6 Pit Installation
- 2.7 Access Ramps
- 3.0 Adjustments and Calibration
- 4.0 Service Information