Rice Lake MC Series Mass Comparator, A&D Weighing - MC-6100 - Manual (Page 50)

48
13. COMMANDS
13-1 Command List
Commands to query weighing data
C Cancels the S or SIR command.
Q Requests the weighing data immediately.
S Requests the weighing data when stabilized.
SI Requests the weighing data immediately.
SIR Requests the weighing data continuously.
E
SC
P Requests the weighing data when stabilized.
Note: The “Q” and “SI” commands, the “S” and “ E
SC
P” commands behave the same.
Commands to control the balance
Note: The “R”, “T”, “Z” and “ E
SC
T” commands behave the same.
Commands to control the comparator function
HI: ∗∗∗. ∗∗ g Sets the upper limit value. e.g.,HI:+2.34 g (to set the upper limit
value to 2.34 g: represents a space.)
LO: ∗∗∗. ∗∗ g Sets the lower limit value. e.g.,LO:+1.23 g (to set the lower limit
value to 1.23 g: represents a space.)
?HI Outputs the upper limit value.
?LO Outputs the lower limit value.
Note: To use a command to control the comparator function, set the “Input method
( Cpin )” parameter to “ 0 ” or “ 1 ”.
Commands to control the memory function
MCL Deletes all data in memory.
MD:nnn Deletes weighing data with the data number nnn.
?MA Outputs all data in memory.
?MQnnn Outputs weighing data with the data number nnn.
?MX Outputs the number of weighing data in memory.
Note: “nnn” indicates a three-digit numerical value.
E
SC
: 1Bh in ASCII code
CAL Same as the CAL key.
OFF Turns the display off.
ON Turns the display on.
P Same as the ON:OFF key
PRT Same as the PRINT key
R Same as the RE-ZERO key
SMP Same as the SAMPLE key.
T Same as the RE-ZERO key
Z Same as the RE-ZERO key
E
SC
T Same as the RE-ZERO key
U Same as the MODE key
UN:mm Changes the unit mass stored in memory with the number of mm (01-20).
?UN Outputs the unit mass number of the selected unit mass.
UW: ∗∗∗. ∗∗ g Sets the unit mass value. e.g.,UW:+0.123 g (to set the unit mass to
0.123 g: represents a space.)
?UW Outputs the unit mass value of the selected unit mass number.
?ID Requests the ID number.
?SN Requests the serial number.
?TN Requests the model name.