Rice Lake Remote Displays/Scoreboards - Laser LT - Manual (Page 16)

12 Laser LT Installation and Operation Manual
3.0 Configuration
Once the Laser LT remote display is installed, it may need to be configured. This can be done manually through the
front panel and is explained in Sections 3.2 through 3.6.
Using Auto-Learn (Section 3.1) simplifies installation by automatically detecting the communications format and
data rate used by the indicator and may eliminate the need for configuration.
Use the Revolution Utility to help configure the Laser LT using your PC. Revolution can be used to program and
configure the Laser LT and is further explained in See Section 3.10 on page 24 of this manual.
3.1 Auto-Learn
The Laser LT remote display incorporates a software feature called Auto-Learn. Auto-Learn examines the serial
data stream sent from the attached indicator and attempts to determine the data settings and format used by the
indicator.
PRI CHR
L=76
PRI LOC
000000
SEC CHR
K - 75
SEC LOC
000000
GRS CHR
G - 71
GRS LOC
000000
NET CHR
N - 78
NET LOC
000000
MOT LOC
000000
LW POS
000000
NET LOC
000000
MOT CHR
M - 77 O - 79
OVR CHR
000000
OVR LOC
COZ LOC
000000
COZ CHR
Z - 90
SP IND
DWM4 1
Toledo
None
LB-OZ
F2500
FRAME BAUD
1200
9600
2400
4800
19200
38400
57600
1115200
BITS
8 NONE
7 ODD
7 EVEN
000000
NEG LOC
[-] 45
NEG CHR
E CHAR
LF
CR
FF
ETX
STX
SOH
CR
LF
FF
ETX
SCHAR SBITS
2
1
On
Off
LEARN
SERIAL TEST KEYPAD DIGIO VERS CONFIG
Figure 3-1. AutoLearn Menu Parameters