Rice Lake Tracer AV - Manual (Page 21)

Tracer AV Installation Manual - Configuration 17
3.2.4 Calibration Menu
See Section 4.0 on page 23 for calibration procedures.
Figure 3-7. Calibration Menu
3.2.5 Serial Menu
See Section 6.3 on page 34 for information about the Tracer AV serial data format.
Figure 3-8. Serial Menu
CALIBR Menu
Parameter Choices Description
Level 2 submenus
WZERO — Display and edit the zero calibration A/D count value.
DO NOT adjust this value after WSPAN has been set!
WVAL — Display and edit the test weight value.
WSPAN — Display and edit the span calibration A/D count value.
REZERO — Press Zero to remove an offset value from the zero and span calibrations.
Use this parameter only after WZERO and WSPAN have been set. See Section 4.2 on
page 24 for more information about using this parameter.
Table 3-6. Calibration Menu Parameters
XXXXXXX XXXXXXX
WZERO WV AL WSPAN
SETPNT PROGRM SERIAL CALIBR CONFIG FORMAT
REZERO
VERS
Press Zero key to
remove offset from
zero and span
calibrations
DEFCAL
XXXXXXX XXXXXXX
EOLDLY
000
number
EDP
BITS TERMIN BAUD
CR
9600
7ODD
7EVEN
8NONE CR/LF
4800
2400
1200
600
300
SETPNT PROGRM SERIAL CALIBR CONFIG FORMAT
ECHO
ON
OFF
VERS
19200
38400
DEFCAL