Rice Lake Tracer AV - Manual (Page 16)

12 Tracer AV Installation Manual
3.1.5 Editing Integers
1. By pressing Units , navigate all the way to the
right (beyond all ‘-’ characters until there are no
segments flashing).
NOTE: The ‘-’ characters are placeholders for appending or
removing digits at the end of numbers that exceed the
six-digit display.
2. Press Zero to accept the modified value.
3.1.6 Editing Floating Point (Decimal Point Position)
1. By pressing Units , navigate all the way to the
right (beyond all ‘-’ characters until there are no
segments flashing).
2. Press Zero to initialize editing of decimal point
position.
3. Press Units to move the decimal point to the desired position.
The decimal point will move forward one position with the Units button and wrap around until the Zero
button is pressed to select the position.
4. When the decimal point is in the desired position, press Zero .
3.2 Menu Structures and Parameter Descriptions
The following sections provide graphic representations of the Tracer AV menu structures. In the actual menu
structure, the settings you choose under each parameter are arranged horizontally. To save page space, menu
choices are shown in vertical columns. The factory default setting appears at the top of each column in bold type.
Most menu diagrams are accompanied by a table that describes all parameters and parameter values associated
with that menu. Default parameter values are shown in bold type.
3.2.1 Default Calibration Menu
Figure 3-4. Default Calibration Menu
Figure 3-3. Editing Procedure for Numeric Values
Change Digit Selection Increment Value/
Save Value Entered
And Return to Level
Above
DEFCAL Menu
Parameter Choices Description
SELECT 500lb
300lb 500lb sets the scale to a primary of 500lb x 1 lb and a secondary of 250kg x .5 kg ;
SP1 trip=50lb; SP2=off; Dig Filter 1=8; Dig Filter 2=8; Dig Filter 3=8; Zero Tracking=3D
300lb sets the scale to a primary of 300lb x 1 lb and a secondary of 150kg x .5kg
SP1 trip=50lb; SP2=off; Dig Filter 1=8; Dig Filter 2=8; Dig Filter 3=8; Zero Tracking = 3D
WZERO — Display and edit the zero calibration A/D count value.
DO NOT adjust this value after WSPAN has been set!
WVAL — Display and edit the test weight value.
WSPAN — Display and edit the span calibration A/D count value.
Table 3-3. Default Calibration Parameters
XXXXXXX XXXXXXX SETPNT PROGRM SERIAL CALIBR CONFIG FORMAT VERS XXXXXXX DEFCAL
SELECT WV AL WSPAN WZERO
500lb
300lb