Rice Lake 920i FlexWeigh Systems - 103 - Manual (Page 22)

18 System 103 Loss-in Weight Dispensing Controls
Print Total
1. Press the Totals softkey (Figure 4-8) to access the Print Total softkey.
2. Press the Print Total softkey to access the following screen.
Figure 4-11. Clear Total Screen
3. Press the Yes softkey to clear the total and sub-total of the batch.
Press the No softkey to exit out of the screen.
4.3 Dispensing Material from a Scale
1. Press the Start button on the unit. The system verifies if:
• E-Stop is pulled out
• A valid target weight is entered
The system verifies the weight to make sure it’s above the target weight and above the low level weight. If
the weight is below the low level weight, it will refill the scale to the high level weight. When the weight
reaches the high level weight, the refill output will turn off.
2. Press the START button to start the dispensing material.
The system does the following during this process.
• Turns off the Dispense Complete and Refill Complete outputs
• Increments the consecutive number by one
• Tares the scale to zero (net mode)
The system begins dispensing either of three speeds while the 920i screen displays real time sequence
progress. The displayed net weight will continue showing more negative as weight is dispensed, until the
target weight presets are achieved.
- - - - -
Target Dribble Preact High Level
Consec. # Subtotal Total
100.0 Lb 75 0.0 500 Lb
2 0.0 Lb 0.0 Lb
Yes
No
05/20/2011 10:31AM SCALE #1
SCALE
#1
Gross
Lb
Low Level
150 Lb
Clear Total?