Rice Lake 920i FlexWeigh Systems - 103 - Manual (Page 11)

Entering the Setup Menu 7
3.0 Setup Menu
The System 103 has various setup parameters. They are explained in further detail in the following sections.
3.1 Entering the Setup Menu
Note that the front panel E-stop button must be in the stopped position (pushed in) to enable any of the
following keypad entries.
1. Press the Setup Menu softkey on the main menu screen and the system performs one of the following
actions.
• If a system password is entered, proceed to Step 2.
• If no system password is entered, the Setup Menu Main Screen will display (see Figure 3-1).
2. Press the Setup Password softkey. The system prompts with Enter Password .
Figure 3-1. Setup Menu Enter Password
3. Enter the password and press the enter key on the 920i. The system checks the entered value against the
system password and performs one of the following actions:
• If the password is valid the Setup Menu Main Screen will display (see Figure 3-2).
• If the password is invalid, Invalid password will display momentarily and display exits the operation.
When the system password criteria is satisfied the following display is shown.
Figure 3-2. Setup Menu Main Screen
Note
05/20/2011 02:15PM SCALE #1
Cancel End
Enter New Password
=>
_ _ _ _ _
SCALE #1
Gross
Lb
Home
Program: Express 103 PN120598 (V 1.00)
ID #1 (disabled) Start O Refill Cmpt
ID #2 (disabled) Resume O Disp Cmpt
Single-Speed (enabled) Reset O Slow Cycle
Auto Print (disabled) Stop O Disp Slow
Delay After Discharge (sec) 3.0 Refill Disp Fast
Setup Menu
05/20/2011 02:15PM SCALE #1
ID #1 More =>
Setup Menu
_ _ _ _ _
SCALE #1
Gross
Lb
Time/Date
Program: Express 103 PN120598 (V 1.00)
ID #1 (disabled) Start O Refill Cmpt
ID #2 (disabled) Resume O Disp Cmpt
Single-Speed (enabled) Reset O Slow Cycle
Auto Print (disabled) Stop O Disp Slow
Delay After Discharge (sec) 3.0 Refill Disp Fast
Setup Menu
Setup
Password ID #2