Rice Lake 920i FlexWeigh Systems - 103 - Manual (Page 14)

10 System 103 Loss-in Weight Dispensing Controls
3.5 Modifying the Dispensing Speeds
Use the following steps to modify the dispensing speeds.
1. From the Main Setup Menu Screen , press the Setup Password softkey (Figure 3-2).
2. Press the More=> softkey to access the second and third menu screens.
Figure 3-7. Setup Main Menu Screen #2
3. Press the Single Speed Enabled, Dual Speed Enabled or Parallel Speed Enabled softkey. The system will
toggle between the three modes of operation.
3.6 Modifying Auto Print
Use the following steps to modify the auto print.
1. From the Main Setup Menu Screen , press the More=> softkey to access the second setup menu screen.
2. Press the Auto Print Enabled or Auto Print Disabled softkey. The system will toggle between the two modes
of operation.
Figure 3-8. Auto Print Disabled Softkey
3.7 Delay After Discharge
Use the following steps to modify the delay after discharge.
1. Cycle through pressing the More => softkey to access the second setup menu screen which includes the
Delay After Discharge softkey.
Figure 3-9. Delay After Discharge Softkey Location
05/20/2011 02:15PM SCALE #1
Auto Print
Enabled More =>
Setup Menu
_ _ _ _ _
SCALE #1
Gross
Lb
<= More
Program: Express 103 PN120598 (V 1.00)
ID #1 (disabled) Start O Refill Cmpt
ID #2 (disabled) Resume O Disp Cmpt
Single-Speed (enabled) Reset O Slow Cycle
Auto Print (disabled) Stop O Disp Slow
Delay After Discharge (sec) 3.0 Refill Disp Fast
Setup Menu
Single-Spd
Enabled
Delay
After Disch
Auto Print
Disabled
05/20/2011 02:15PM SCALE #1
Auto Print
Enabled More =>
Setup Menu
_ _ _ _ _
SCALE #1
Gross
Lb
<= More
Program: Express 103 PN120598 (V 1.00)
ID #1 (disabled) Start O Refill Cmpt
ID #2 (disabled) Resume O Disp Cmpt
Single-Speed (enabled) Reset O Slow Cycle
Auto Print (disabled) Stop O Disp Slow
Delay After Discharge (sec) 3.0 Refill Disp Fast
Setup Menu
Single-Spd
Enabled
Delay
After Disch