Kontron AM4220 - Manual (Page 56)

41 AM4220
www.kontron.com
5.1.3 OEM commands
5.1.3.1 OEM Get Firmware SysUpTime
5.1.3.2 OEM Get Serial Configuration
Example: Using onboard
ipmitool –l 3 raw 0x30 0x5 0xab 0xca 0xca 0xce 0xc9
Command Name LUN NetFn Command Number
OEM Get Firmware SysUpTime 3 0x3E 0x03
Byte Num Data Field / Byte Raw
Request Data 1...4 0xBA 0x90 0x91 0x8B
Response Data 1 Completion Code
2...5 System Up-Time in Seconds
Command Name LUN NetFn Command Number
OemApGetSerialconfig 3 0x30 0x05
Byte Num Data Field / Byte Raw
Request Data 1...5 0xAB 0xCA 0xCA 0xCE 0xC9
Response Data 1 Completion Code
2 MUX setting
3 UART0 config
4 UART1 config
5 MMC SPI config
6 Reserved
Setting [reg.config] – UART0 [reg.config] – UART1 [reg.config] – MMC
0 [3/4] – CableDetect/SOL [0] – not connected -
1 [0] – not connected [3/4] – CableDetect/SOL -
2 [3] – CableDetect [4] – SOL -
3 [4] – SOL [3] – CableDetect -
4 [1] – Front [2/4] – Rear/SOL (AM4220 only) -
5 [2/4] – Rear/SOL [1] – Front (AM4220 only) -
6 [1/4] – Front/SOL [2] – Rear (AM4220 only) -
7 [2] – Rear [1/4] – Front/SOL (AM4220 only) -
8 [4] – SOL [0] – not connected [2] – Rear
9 [4] – SOL [0] – not connected [1] – Front