Kontron AM4220 - Manual (Page 38)

23 AM4220
www.kontron.com
3.5.1 Usage
cfgtool [--help|-h][--status|-t][--interface|-i][--pcie|-p][--clock|-k][--set|-s][--cycle|-
c][--nofru|-n][--debug|-d]
The following options are recognized:
-h show possible settings available for this board
-t show current running configuration
-i Interface setting
-p PCIe setting
-k clock setting
-s set configuration (change HW setting and update ekeying info)
-c perform power cycle of payload power to activate settings
-n no FRU data modification
-d debug flag
Detailed description of these options:
• -h | --help
This option shows a list of possible settings.
• -t | --status
This option shows the present configuration stored in NV ram of the MMC. This setting will take affect
after invoking a “Chassis Control Power cycle” command or after a complete hotswap cycle with remove
and reinsertion of the module.
• -I | --interface
This option checks if the setting is possible for this board. To set this setting the [–s|--set]
options has to be appended.
• -p | --pcie
This option checks if the setting is possible for this board. To set this setting the [–s|--set]
options has to be appended.
• -k | --clock
This option checks if the setting is possible for this board. To set this setting the [-s|--set]
options has to be appended.
• -s | --set
This option set the configuration in the MMCs NV ram, updates the FRU data multirecord and performs a
MMC reset (IPMI Cold Reset).
• -c | --cycle
This option send the IPMI command “Chassis control Power cycle” to the MMC to perform a payload power
cycle. During the power cycle the configuration will be enabled. This option is allowed without any other
options or when a valid PCIe or Interface setting is configured and activated with the [–s|--set] option.