Kontron AM4220 - Manual (Page 33)

18 AM4220
www.kontron.com
Enter 'help' for a list of built-in commands.
~ #
3.4.3 Access over Ethernet Interface
The AM4220 can be accessed by using the Ethernet Interface AMC port 0 (eth0).
By default, DHCP is configured for this Interface.
There is also a possibility to access the AM4220 using one of the SFP+ on the front plate. Both interfaces are
not configured by default and must be setup accordingly by editing the file /mnt/etc/rc.local.
3.4.4 Using SoL over AMC Port 0 on AM4220
3.4.4.1 Requirements
• AM4220
• ATCA carrier or uTCA System providing access to AMC connector port 0
• Linux host with Ethernet interface
• SFP+ module for Ethernet connection to the Linux host
• ipmitool v1.8.9 ( http://ipmitool.sourceforge.net/ )
3.4.4.2 Configure IOL (IPMI over LAN)
In preparation for configuring SOL, the IOL interface has to be configured first. This is done by establishing a
telnet connection via SFP1.
The interface SFP1 has a fixed configured IP address: 192.168.0.100
The Ethernet interface of the Linux host must be configured for accessing the IP address 192.168.0.100. An
IP connection from the Linux host to SFP 1 of the AM4220 must be possible.
Connect to the AM4220 via telnet
Check board information (optional)
~ # /mnt/bin/ipmitool mc info
Device ID : 6
Device Revision : 0
Firmware Revision : 5.24
IPMI Version : 1.5
Manufacturer ID : 15000
Manufacturer Name : Kontron
Product ID : 5516 (0x158c)
Device Available : yes
Provides Device SDRs : yes