beautypg.com

5 sata (serial ata) disk interface (j21 – j26), Sata (serial ata) disk interface (j21 – j26), Internal connectors – Kontron KTHM76-mITX User Manual

Page 42

background image

KTQM77 – KTHM76 Users Guide

KTD-N0850-F Page 42

6.5 SATA (Serial ATA) Disk interface (J21 – J26)

The KTQM77 has an integrated SATA Host controller (PCH in the QM77 chipset) that supports

independent DMA operation on six ports. One device can be installed on each port for a maximum of six

SATA devices. A point-to-point interface (SATA cable) is used for host to device connections. Data

transfer rates of up to 6.0Gb/s (typically 600MB/s) on SATA0 and SATA1 and 3.0Gb/s (typically

300MB/s) on SATA2, SATA3, SATA4 and SATA5. SATA2 is shared with mPCIe0.

Note: Before installing OS on a SATA drive make sure the drive is not a former member of a RAID

system. If so some hidden data on the disk has to be erased. To do this, connect two SATA drives and

select RAID in BIOS. Save settings and select while booting to enter the RAID setup menu.

Now the hidden RAID data will be erased from the selected SATA drive.

The SATA controller supports:

RAID (Redundant Array of Independent Drives) based on a firmware system (KTQM77/mITX only):

2 to 6-drive RAID 0 (data striping)

2-drive RAID 1 (data mirroring)

3 to 6-drive RAID 5 (block-level striping with parity)

4-drive RAID 10 (data striping and mirroring)

2 to 6-drive matrix RAID, parts of a single drive can be assigned to different RAIDs

AHCI (Advanced Host Controller Interface)

NCQ (Native Command Queuing). NCQ is for faster data access.

Hot Swap

Intel® Rapid Recover Technology

2 – 256TB volume (Data volumes only)

Capacity expansion

TRIM in Windows 7 (in AHCI and RAID mode for drives not part of a RAID volume). (TRIM is for

SSD data garbage handling).

SATA connector pinning:

SATA0 (J21), SATA1 (J22), SATA2 (J23), SATA3 (J24), SATA4 (J25) and SATA5 (J26).

PIN

Signal

Type Ioh/Iol Pull

U/D Note

1

GND

PWR

-

-

2

SATA* TX+

3

SATA* TX-

4

GND

PWR

-

-

5

SATA* RX-

6

SATA* RX+

7

GND

PWR

-

-

Signal

Description

SATA* RX+

SATA* RX-

Host transmitter differential signal pair

SATA* TX+

SATA* TX-

Host receiver differential signal pair

“*” specifies 0, 1, 2, 3, 4, 5 depending on SATA port.

Available cable kit:

PN 821035 Cable SATA 500mm

Internal Connectors

This manual is related to the following products: