Gastroback 41408 Design Mincer Pro M - Manual (Page 9)

33
Operation
WARNING: The mincer is intended for mincing food. For this, the appliance is equipped
with sharp-edged knives and other electrically driven moving parts. Do not insert your
hands or any foreign objects (e.g. cooking utensils) in the feed tube, or
outlet of the cutter housing while the appliance is connected to the power
supply, to avoid risks of injuries.
Always switch OFF the ON/OFF button first, then switch OFF the power switch, then unplug
the appliance, before assembling or disassembling any parts. Before operation, always
ensure that you have assembled the appliance completely and correctly according to the
instructions in this booklet, and that there are no foreign objects in the feed tube. Carefully
remove hard, uneatable parts of your foods (e.g. bones, gristle, sinews, seeds, stalks, hard
shells) completely, before mincing.
Do not place clothes, tissues or any other foreign objects on or under the appliance during
operation. Do not place the appliance over a power cord. Only use the provided pusher
with the appliance. Do not use any hard or sharp-edged objects (e.g. forks, knives), to avoid
damage to the appliance. Do not cut your foods on the tray of the appliance. Do not use
violence!
Assembling the Appliance
WARNING: Only place the motor housing on a stable, dry, level, and clean surface. Do
not place any clothes or tissue or other foreign objects on or under the appliance during ope-
ration, to avoid risk of fire or electric shock. Do not block the ventilation slots at the bottom
of the motor housing. The buttons for operation and the power switch must be accessible any
time, during operation.
Always ensure that the appliance is NOT connected to the power supply, before assembling
or disassembling the appliance.
Do not pour any liquids over or in the motor housing! Do not pour any liquids in the feed
tube with the cutter housing connected to the motor housing! Always immediately switch
OFF and unplug the appliance, if liquids are spilled on or in the appliance. Then clean the
appliance and let it dry naturally for one day. (See: Care and Cleaning)
1. Place the motor housing on a flat, stable, and moisture-resistant surface near a suitable
wall power outlet. (See: Important Safeguards) Leave at least 10 cm of free space to walls,
curtains, boards and other objects on each side of the appliance. Leave at least 50 cm of
free space above and in front of the appliance to get free access.
2. Hold the cutter housing with the threaded end upwards. Then insert the worm shaft into
the cutter housing, the smaller end with the cogwheel pointing downwards. Doing so, put the
cogwheel through the opening in the lower end of the cutter housing.
3. Insert the appropriate tools.
WARNING: The cutter blade is very sharp-edged. Handle with care! Always assemble only
one matching set of tools. For mincing and mixing, only use one of the provided grinding
discs.