Gastroback 41408 Design Mincer Pro M - Manual (Page 17)

41
completely (ON/OFF button and power switch), unplug and clean the appliance according
to the instructions in chapter Care and Cleaning. However, if the problem persists, slow
down working and cut your foods to smaller pieces, before processing in the mincer (See:
Properties of Your Design Mincer Pro M).
Overheat Protection
This appliance is equipped with an overheat protection that will automatically shut off the
appliance in case of overheating.
If your appliance suddenly stops running:
1. Immediately unplug the appliance and press the power switch and ON/OFF button to turn
off the appliance.
2. Let the appliance cool down, then clean the appliance (see: Care and Cleaning).
3. Wait 60 minutes.
4. Insert the mains plug in the power socket.
5. Now you can operate the appliance as usual. However, if the appliance will not work
again, send the complete appliance to an authorized service centre for examination and
repair.
Slow down your work-speed and use smaller portions. Regularly, switch OFF the appliance
in between times for 15 minutes. Please contact you vendor or an authorized service centre,
if the overheat protection is activated too often, anyhow.
Care and Cleaning
WARNING: Do not insert your hands or any foreign objects in the feed tube or outlet of the
cutter housing, while the appliance is connected to the power supply.
The cutter blade is sharp-edged. Handle with care to avoid cutting your fingers.
Do not place or immerse the motor housing or power cord in water or any other liquids.
Do not spill any liquids on the motor housing or power cord. Do not pour any liquids in the
feed tube, while the cutter housing is assembled to the motor housing. Always disconnect
the cutter housing from the motor housing, before assembling or disassembling any tools or
removing stubborn blockages.
Do not place the appliance or any part of it in an automatic dishwasher.
Do not leave any food dry up on the appliance or any parts of it to prevent a build up of
dried-on foods. Always clean the appliance after each use according to the following instruc-
tions.
Disassembling the Appliance
WARNING! Always switch OFF the ON/OFF button and power switch, wait until the
motor comes to complete standstill, and unplug from power outlet, before disassembling or
cleaning the appliance.
1. Switch OFF the ON/OFF button and power switch, wait until the motor comes to complete
standstill, and unplug from power outlet.
2. Remove the pusher. Then lift the tablet upwards to remove it.