Unlocking the unit – FBT QUBE SP27 User Manual

Page 29

Unlocking the Unit

To unlock the unit press

and then type the code in. This can be entered by using the

control to

select a character, and the

and

keys to move to the next character. Alternatively, the

keys

can be used to enter a code by pressing any combination of the eight buttons. Each

key represents its

channel labelling, as described in the locking section.

Don't panic! Your unit can still be unlocked. In an attempt to improve the security system on the SP27, and
prevent a standard master password from becoming common knowledge, the units now have a random
password key generator.

The procedure for unlocking a unit using the password override is explained below:

Switch the unit on with the

key held in momentarily. After a few seconds, the unit will ask for a security

code. Use the

keys in the same manner as for entering lock codes (see page for details) and enter

2121.

The display will show:

Enter Supplied Code:

Break Code = 12345 [NNNN]

The Break Code (in the example 12345) should be noted and supplied. We have software to generate the
corresponding Pass Code which should be typed in, followed by

. This will unlock the unit and wipe

the previous password.

Note the following about this procedure:

Once the Break Code has been noted, do NOT press

again during the operation of the unit (except to

get back to this point on power up), or a different code will be generated. The unit may be used as normal, but
every press of

will change the Break Code, so the Pass Code supply will not work!

The unit may be switched on and off as necessary – just be sure NOT to press

, or the entire Break

Code procedure will have to be repeated.

ENTER

FREQ

BACK

NEXT

EDIT

MENU

EDIT

ENTER

MENU

Forgotten the Password?