ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) - Manual (Page 32)

Hand Control Unit MODEL 2080 / 2081 TURNTABLE SERIES
28 © ETS-LINDGREN L.P. – JANUARY 2003
REV C – PN 399228
HAND CONTROL UNIT
To connect the Hand Control Unit (HCU), remove the connector
cap on the motor base. Plug the cable receptacle from the hand
control unit into the electrical enclosure and screw connectors
completely together. The HCU is now ready to operate. Be sure to
coordinate use of the unit with the operator of the Model 2090
Positioning Controller.
To allow the HCU to operate, push the control switch from MAIN
to HAND. When the HCU is selected, the Model 2090 Positioning
Controller is overridden until control is returned from the HCU. If
the Model 2090 Positioning Controller is left on while the HCU is
used, all changes in position are recorded by the Model 2090
Device Positioner.
CAUTION Do not plug the hand control unit into the motor base
while that device is operational. Coordinate with the operator of
the Model 2090 Positioning Controller before plugging in, using,
or unplugging. Do not push the CD and CCW buttons at the same
time. Be sure that the motor is completely stopped before reversing
direction with the unit.
When you are ready to change to automated testing, toggle the
control switch from HAND to MAIN.
Archived 3/18/10