ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) - Manual (Page 15)

MODEL 2080 / 2081 TURNTABLE SERIES Turntable Installation Instructions
© ETS-LINDGREN L.P. – JANUARY 2003 11
REV C – PN 399228
11. While the ½-13x5 square head screws are all identical, they
serve two purposes. The screws installed in step 9 anchor the
assembly through the anchor plates and into the floor. The
screws you are about to manipulate will level the assembly
with the raised floor or ground plane. Please refer to the
drawings at the back of this manual to determine which screws
serve each purpose. The screws which anchor the unit have an
A by their receptacle hole on the plan view of the turntable.
Using a leveling instrument, (torpedo laser level or some other
device), the leveling screws should be turned, to raise the table
until it is between 1/8” and 3/16” above the raised floor, this is
just a rough finish height. It is easier to lower one leveling
screw in each group and then lower the second after the floor
flange has been mounted. Once you have one screw in each
group leveling the assembly and the turntable is level, lock
down the flange nut to hold the table in place while the
turntable floor flange is being mounted.
Archived 3/18/10