ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) - Manual (Page 17)

MODEL 2080 / 2081 TURNTABLE SERIES Turntable Installation Instructions
© ETS-LINDGREN L.P. – JANUARY 2003 13
REV C – PN 399228
have more than 1/16" gap between the butt joint when finished.
Continue mounting as stated above until all screws have been
installed. Also the top floor joint strips will need to be trimmed to
fit up against the flange.
2081 INSTALLATION OF STAINLESS
STEEL WEAR STRIP
Tools and Hardware Needed:
‰ eight small 1-1/2” C-clamps
‰ 6-32x 3/8” thread rolling screws
‰ hand drill
‰ 0.120 dia. drill bits
‰ a #2 phillips bit
‰ cutting oil
It is very important that the floor around the TT pit is level all the
way around. If it is not, it will make the installation of the wear
strip very difficult. Start the strip 1/8" below the surface of the
flange at the end with the hole closest to the end of the strip. Also
start with the first 2 holes in the strip between the casters. Place a
clamp about 2” on each side of the hole on the strip in 4 places.
Transfer drill .120 dia. holes into the aluminum floor flange and
screw in the 6-32 x 3/8” thread rolling screws.
NOTE: Some of the pre-drilled holes in the strip will be in the path
of a caster. For these holes, casters will need to be removed by
taking out the center axle of the caster. Be careful not to lose any
washers or allow the washers to fall out.
NOTE: Be careful not to bend the stainless steel strip, this will
make it difficult to install properly. Do not let the stainless steel
strip come up above the top of floor flange since it may bend
when something heavy is rolled over it. It will be beneficial to be
slightly below the surface of the flange.
Continue installation around the TT with the strip. When you get
to the end, you will need to cut the strip to length. Let the strip
overlap the fixed end. Using your square, mark a line even with the
Archived 3/18/10