Tools required – ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) User Manual
Page 12
Turntable Installation Instructions
MODEL 2080 / 2081 TURNTABLE SERIES
8
© ETS-LINDGREN L.P. – JANUARY 2003
REV C – PN 399228
TOOLS REQUIRED
3/16” allen wrench
5/16” allen wrench
3/8” allen wrenches, qty 3
6 m.m. allen wrench
3/8” ratchet wrench
12” crescent wrench
15 m.m. 12 point socket for ½” square head screws
7/16” open/box end wrench
½” open/box end wrench
¾” open/box end wrench
.120 drill bit for 6-32 self tapping screws
“A” & “B” drill for ¼-20 self tapping flat head screws
27/64” drill bit for ½”-13 tap
3/8” hand drill
½”–13 tap
#2 phillips screw bit
#3 phillips screw bit
Measuring tape
Pry bar
Level
Square
Hacksaw
Black sharpie marker
File
WD 40
¾” pipe clamp ends
¾” pipe (length depends on table size 6 ft. will cover most tables)
1- ½” C-clamps, qty 8
Cutting Oil
Syringe for applying conductive grease
Grease Gun
Vacuum Cleaner
Concrete Pit Installations
½”“ hammer drill
½” x 12” masonry bit
3/16” x 6” masonry bit
¼” x 1-3/4” Tapcon Screws or equivalent
Archived 3/18/10