ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) - Manual (Page 11)

MODEL 2080 / 2081 TURNTABLE SERIES Turntable Installation Instructions
© ETS-LINDGREN L.P. – JANUARY 2003 7
REV C – PN 399228
GUIDELINES
Proper installation of the turntable directly affects performance.
While the Model 2080 and 2081 turntables are shipped fully
assembled, there are additional parts for installing the turntable.
The installation process includes placing and centering the
turntable at the installation location, inserting the floor anchor
plates and leveling screws, leveling the turntable, installing the
floor flange and wear strip if applicable.
Uncrate all parts. Check all parts for any shipping damage. Ensure
a clear area is available to install the turntable safely.
NOTE: Do not discard any packing material until the unit is fully
installed and verified.
CAUTION Ensure power is OFF and secured before proceeding
further. The voltage select switch on the motor base unit must be
set to the proper mains voltage before power is applied to the unit.
The 1.2 and 1.5 meter models allow for the selection of either 115
or 230 VAC single phase, 50 or 60 Hz. This selection should be
made during the initial installation and prior to applying mains
power. There is a separate electrical installation section following
the turntable installation instructions that will guide you through
this process.
Verify that the fiber optic cable is long enough to reach from the
turntable to the control room or station. Avoid pulling on the fiber
optic cable or damaging the connectors.
When working around the turntable avoid stepping on the fiber
optic connectors located at the motor base. The fiber optic cable
should not be attached to the motor base during the physical
installation process.
Archived 3/18/10