2081 raised panel floor flange installation – ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) User Manual

Page 16

Turntable Installation Instructions

MODEL 2080 / 2081 TURNTABLE SERIES

REV C – PN 399228

2081 RAISED PANEL FLOOR FLANGE
INSTALLATION

For this step you will need:

pipe clamp

three 3/8” allen wrenches

hand drill

5/32” drill bit

#3 phillips drive bit

a small square

marker

¼”x 1-3/4” phillips flat head

TAPCON screws

hacksaw

1.2 and 1.5 meter turntables with the floor flange option have two
floor flange pieces. All of the flanges are cut oversize for bending
purposes and the only one that will need to be cut is the last flange
installed.

Using a pipe clamp and 3/8” allen wrenches or 3/8” pin, place a
spacer between the TT and flange starting in three places in the
center or on the flange. Once there is tension on all three wrenches,
drill a 5/32” hole through the counter-sunk holes in the floor
flange. Drill completely through the panel and place screws into
the holes. Continue working around the flange doing 2 or 3 holes
at a time. Some screws may fall between the floor panel joints.
Try to position the flanges ensuring as few screws hit these points
as possible making sure that the first or last hole in the flange are
not too close to one of these joints.

NOTE: It is very important that this 3/8” gap between TT and floor
flange be held as close as possible so that the grounding brushes
seat properly. Also make sure that the flange ends are flush with
each other.

Typically the last flange will be too long. Turn the flange upside
down, butt one end to the other and evenly mark off with the other
end and trim to fit. Do not cut too much off. It is preferable to not

Archived 3/18/10

This manual is related to the following products:

2080 Turntable Series 1.2m/1.5m (Archived)