ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) - Manual (Page 10)

Turntable Installation Instructions MODEL 2080 / 2081 TURNTABLE SERIES
6 © ETS-LINDGREN L.P. – JANUARY 2003
REV C – PN 399228
TURNTABLE INSTALLATION
INSTRUCTIONS
GLOSSARY
Anchor Plate – Anchors the turntable to the floor and provides an
interface for leveling screws.
Leveling Screws – (½-13x5” square head screws with ½-13
flangenuts) work in concert to level the turntable assembly. The
screws are shipped inserted into the turntable base.
Anchor Plate Screws – (#14x1” #3 square socket flat head
screws) These screws will connect the anchor plates to the floor. If
the turntable is being installed in a concrete pit please contact the
factory for additional supplies.
Floor Flange – Mounts to the ground plane around the turntable
perimeter. The floor flange works in conjunction with the wear
strip and ground brushes to electrically couple the turntable to the
ground plane. (not applicable to the Model 2080)
Stainless Steel Wear Strip- Serves as a wear point to prolong the
life of both the ground brush and floor flange. This piece is
attached to the floor flange during the installation process.
Archived 3/18/10