ETS-Lindgren 2081 Turntable Series 1.2m/1.5m (Archived) - Manual (Page 13)

MODEL 2080 / 2081 TURNTABLE SERIES Turntable Installation Instructions
© ETS-LINDGREN L.P. – JANUARY 2003 9
REV C – PN 399228
INSTALLATION
During the installation process please refer to the drawings at the
back of this manual.
1. If the turntable is to be installed in a pit, check the pit depth
and inside diameter and compare measurements to the site
drawings. Inside pit dimensions are typically as follows:
Model 2080
1.21 meter = 49.65”
1.51 meter = 61.46”
Model 2081
1.23 meter = 50.44”
1.53 meter = 62.25”
If the turntable is a non-standard size then multiply meter size
x 39.38” and add 2” for the finished pit inner diameter. These
dimensions are +/- ¼”.
2. The location where the turntable will be installed should be as
level as possible, and perpendicular to the room, before
proceeding with the installation. It may be necessary to place
shims on the floor to level it out before installing the anchor
plates. The more level the installation surface is before
installation, the faster the leveling process should go during
installation.
IMPORTANT When installing a turntable in a chamber with a
raised floor, additional support under the floor will be
necessary around the edge of the turntable.
3. Remove the top of the turntable by removing all necessary
screws.
4. Lower the base of the turntable into the pit and position the
motor base with the fiber optic connectors pointing in the
direction that the fiber optic cable will be installed. This will
reduce the chance of the cable being kinked or bent.
5. Center the turntable in the pit by measuring from the bearing to
the I.D. of the raised floor. Measure in at least 8 places and
equally divide the difference. Once you have found the center,
and moved the turntable base into position, using a marker,
Archived 3/18/10