ETS-Lindgren 2115 Multi-Axis Positioning Systems (MAPS) - Manual (Page 23)

Installation | 23
14. Remove the bracket mounted on the drive unit that is attached to cable carrier.
Two #6 screws hold the bracket to the unit.
15. Remove the cable clip holding the power cable.
16. Remove the bracket on the opposite side of the unit that ties the drive unit to the
turntable top. This temporary bracket holds the unit in place for shipping.
17. Turn the brake knob to release the drive unit and allow it to move toward center of
table.
When the turntable top is in place, use the brake knob to adjust the EUT to the
center of rotation (middle of the quiet zone) by sliding the mast assembly back
and forth.
18. Remove the two 1/4–20 hex head screws that hold the wood top support bracket,
and then remove the bracket.
19. Slide the drive unit carrier out.
20. Reinstall in reverse order.
The brake knob must be in the upper position to allow the drive unit to slide
onto the rail system. Verify all hardware is secured.
Bore Sight and Leveling
If the MAPS unit was ordered with multiple masts, you must bore sight
each mast.
B ORE S IGHT
LASER WARNING. Denotes a laser is part of the operating system of the
device.
Bore sight of the MAPS is critical to the accuracy of measurements, and is the
most important step of the installation process. Take the time to verify all
measurements are accurate.