ETS-Lindgren SMART 1000 Mini-Reverb Cell - Manual (Page 17)

Tuners | 17
3.0 Tuners
General Precautions
Do not stand beneath the horizontal tuner or in
the path of the vertical tuner while they are
under remote control or moving. It is
recommended that a warning indication or
barrier be placed in the chamber to reduce the
risk of damage or injury during operation.
Do not use abrasives on the tuner assembly.
Clean only with vacuum or by dusting.
The tuners must never be turned manually by
pushing the tuners (except SMART 1000
tuners). This could result in damage to the
support shaft or motor/gear box assembly.
Do not fit any additional loads to the tuner
assemblies. The motor acceleration and
deceleration profiles have been set to account
for the inertia of the tuners; changing the loads
could overstress the couplings or gear box
assembly. Manually running the tuners at
speeds in excess of the preset limits could also
result in damage and should not be performed.
Do not cover any surface of the tuners. This
could affect the performance of the chamber.
For the SMART 1000 tuners, the zero or home
position is indicated with a mark in the
chamber; see the following illustration.
See Maintenance on page 9 for information on recommended tuner
maintenance and cleaning.